@air
2025-04-15

What are the main reasons for the high maintenance costs of oil-injected air compressors?

A. Lubricating oil and oil filter needs to be replaced regularly
B. Short equipment life
C. high energy consumption
D. Compressed air has high oil content

Answer: A
Analysis: Oil injection air compressors require regular replacement of lubricants and oil filters, which increases maintenance costs.

Welcome!

Related Articles:
@air
2025-04-15

What is the energy consumption of oilless air compressors usually?

A. Higher B. Lower C. Same as oil injection air compressor D. The answer cannot be determined: B Analysis: Oil-free air compressors usually consume less energy and improve energy efficiency due to reduced use of lubricating oil.

@air
2025-04-15

14. The nominal displacement of an air compressor is 20m³/min, and the measured gas production is 16.8 m ³/min. The possible reasons are not included?

A. An altitude of 1500 meters causes intake pressure loss B. After-treatment equipment pressure loss 6% C. The capacity of the air storage tank is too large D. The ambient temperature is too high Answer: C Analysis: Insufficient capacity of the gas storage tank is a problem. Too large will not affect the gas production…

@ggao
2025-03-12

What environmental benefits can businesses expect from using the GWL Series compressor?

Answer: Reduced energy consumption, lower carbon footprint, and compliance with environmental regulations.

@air
2025-04-15

The advantages of oil-injected air compressors do not include which of the following?

A. Lower cost B. Simple maintenance C. Compressed air pure D. Wide application range Answer: C analysis: The advantages of oil-injected air compressors include low cost, simple maintenance and wide application range, but the compressed air has a high oil content…

@air
2025-04-15

8. For every 50 meters increase in the pipeline, the pressure drop increases by about?

A. 0.05 bar B. 0.1 bar C. 0.2 bar D. 0.5 Bar Answer: B Analysis: The pressure drop per 50 meters of pipeline increases by 0.1 bar, and the flow loss is about 2%.